Difference between revisions of "Engine Specs - S54 Rod Bolts"

From Wiki-DIY
Jump to: navigation, search
(SPEC: OEM: Torque procedure)
(SPEC: OEM: Torque procedure)
 
Line 33: Line 33:
  
 
=== OEM Rod Bolts (M10 x 1.25, E12 Torx bolt head) ===
 
=== OEM Rod Bolts (M10 x 1.25, E12 Torx bolt head) ===
 
==== SPEC: OEM: Torque procedure ====
 
  
 
==== SPEC: OEM: Torque procedure ====
 
==== SPEC: OEM: Torque procedure ====

Latest revision as of 14:52, 2 December 2016


Rod Bolt Comparisons

The S54 has two different types of connecting rod bolts. The torque procedure for each is different.

  • Type-1: M11 x 1.25 mm thread pitch. 12 mm bi-hexagonal bolt head.
  • Type-2: M10 x 1.25 mm thread pitch. E12 Torx bolt head.

OEM Rod Bolts (M11 x 1.25, 12mm bi-hex bolt head)

SPEC: OEM: Torque procedure

Torque Angle
30 Nm 70 degrees
Remove bearing cap  
30 Nm 70 degrees


Make sure you are starting with new rod bolts.  Factory rod bolts must be replaced once used.

  1. Lubricate rod bolt threads and connecting rod cap bore holes with appropriate thread lubricant.
  2. Torque to 30-Nm, then using a torque-angle gauge tighten another 70-degrees.
  3. Remove bolts.
  4. Repeat steps 1, 2.

OEM Rod Bolts (M10 x 1.25, E12 Torx bolt head)

SPEC: OEM: Torque procedure

Torque Angle
30 Nm 105 degrees
Release bolts  
30 Nm 105 degrees
Release bolts  
30 Nm 105 degrees


Make sure you are starting with new rod bolts.  Factory rod bolts must be replaced once used.

  1. Lubricate rod bolt threads and connecting rod cap bore holes with appropriate thread lubricant.
  2. Torque to 30-Nm, then using a torque-angle gauge tighten another 105-degrees.
  3. Release bolts.
  4. Repeat steps 1-3
  5. Repeat steps 1, 2.