BE-FAQ - Bearing measurement marks

From Wiki-DIY
Revision as of 17:20, 3 July 2022 by Rcollins (talk | contribs)
Jump to: navigation, search

Let me explain why BE Bearings have marks on the surface.

Every BE Bearing is hand measured. The measurement process uses a data logging Mitutoyo drop indicator with a rounded roller bearing tip (P/N: 543-562ACAL). The roller bearing tip is like a wheel that rolls over the surface of the bearing while it measures the bearing thickness. This process leaves a very small mark on the surface of the bearing. The marks that this process leaves are totally harmless, and you will never be able to fill them with your fingers or even measurement with another device.

As the shells are hand measured, they are sorted and placed in bins according to every 0.00005 inch difference. The measuring, sorting, and binning allows us to advantage of the normal distribution curve of bearing thicknesses to create perfectly matched sets of bearings for each customer. Once the bearings are sorted and binned, they are then used to create matched sets. This article describes how we mix and match individual shells to create perfectly matched sets of bearings.

Q&A:

Q: Does this process hurt the bearings?
A: No, the marks are only on the surface and do not cause any damage to the shells. You can't even feel them or measure them with another devices.

Q: What if I want a set that doesn't have these marks? Can I get a set that isn't measured?
A: Yes, upon special request, you may obtain a set of bearings that are not measured. We do not advise to do this. Since the issue of the S65 bearing clearances is exacerbated by tolerance stacking, measuring, sorting, binning, and creating matched set of bearings is the only way to eliminate the bearings themselves from contributing to the bearing clearance problem. If you do decide that you want a set that hasn't been measured, then you will be giving up the engine replacement warranty offered by BE Bearings. That engine replacement warranty is described here.

Q: Has BE Bearings always measured their shells?
A: Yes. Since the very beginning in 2015, BE Bearings has always measured their shells.

  1. The first devices as a Mitutoyo ball-anvil micrometer. This device seemed like a good idea, but proved too time consuming and did not produce repeatable results. Measuring each shell took approximately 21 seconds.
  2. The second device was a Mitutoyo 543-562A drop indicator with a ball-shaped tip. This device is accurate to 0.00005 inch with resolution to 0.00002 inch. This device has been used since 2017. This device proved very reliable and repeatable. The ball-shaped tip seemed to scrape the shells a little more than desired and was eventually replaced. Measuring each shell took approximately 7.5 seconds.
  3. More recently, the ball-shaped tip has been replaced with a ball-shaped roller bearing. The roller bearing does not scrape the bearing surface, but does still leave visiable marks. There are no harm caused by these marks and they cannot be felt by your fingers or measured with any device that you may have. Measuring each shell takes approximately 6.0 seconds.
  4. Starting late 2022, a new device will be used. A custom-made Mahr air gage will be used. This new device is accurate to 0.000002 inch, with resolution to 0.000001 inch. This new air gage will use differential air pressure to measure the bearing thicknesses. It's unknown how much time it will take to measure each shell with this technique, but it should be approximately 6.0 - 7.0 seconds.